OEM Restraints System Part Replacement Search

DISABLE PROCEDURE AND TIME (Always Check Service Manual)

1) Turn the ignition switch OFF
2) Ground the SCS line with the HDS to take the ECM/PCM out of active status
3) Disconnect the negative cable from the battery
4) Wait at least 3 minutes before beginning work

Before removing any of the SRS parts (including the disconnection of the connectors), always disconnect the SRS connector.

REV: 04/2011

PARTS THAT MUST BE REPLACED FOLLOWING A DEPLOYMENT

After a collision where the seat belt tensioners deployed, replace these items:
• SRS unit [MODULE,AIRBAG CONTROL]
• Seat belt tensioners
• Front impact sensors [AIRBAG SENSOR,FENDER]

After a collision where the front airbag(s) deployed, replace these items:
• SRS unit [MODULE,AIRBAG CONTROL]
• Deployed airbag(s) [AIRBAG,STEERING WHEEL; AIRBAG,INSTRUMENT PNL]
• Seat belt tensioners
• Front impact sensors [AIRBAG SENSOR,FENDER]

After a collision where the side airbag(s) deployed, replace these items:
• SRS unit [MODULE,AIRBAG CONTROL]
• Deployed side airbag(s) [AIRBAG,FRONT SEAT]
• Side impact sensor(s) (first) for the side(s) that deployed [AIRBAG SENSOR,INTERIOR]
• After a collision in which the side airbag was deployed, replace the seat-back cover.

After a collision where the side curtain airbag(s) deployed, replace these items:
• SRS unit [MODULE,AIRBAG CONTROL]
• Deployed side curtain airbag(s) [AIRBAG,ROOF]
• Side impact sensor(s) (first) for the side(s) that deployed [AIRBAG SENSOR,INTERIOR]
• Side impact sensor(s) (second) for the side(s) that deployed [AIRBAG SENSOR,INTERIOR]
• Roof trim/ Headliner
• A-pillar trim
• B-pillar upper trim
• C-pillar trim
• Front grab handle
• Any related trim clips
• Sunvisor

PARTS THAT MUST BE INSPECTED AND REPLACED IF DAMAGED

NOTE: Before doing any SRS repairs, use the HDS SRS Menu Method to check for DTCs; refer to the DTC Troubleshooting Index for the less obvious deployed parts (seat belt tensioners, front impact sensors, side impact sensors, etc.).

During the repair process, inspect these areas:
• Inspect all the SRS wire harnesses. Replace, do not repair, any damaged harnesses.
• Inspect the cable reel for heat damage. If there is any damage, replace the cable reel. [CLOCK SPRING]

• After a moderate to severe side or rear collision, inspect for any damage on the side curtain airbag or other related components. According to the degree of damage, replace components as needed.

• After a collision in which the side airbag was deployed, if the seat-back cushion is split, it must be replaced. If the seat-back frame is deformed, it must be replaced.

• Any restraint system part or wiring identified by diagnostic check